Whirlpool ET14DC - Manual (Page 4)

Remove the shipping block...
Shipping Biock
Must Be Removed
Install properly...
A Styrofoam
block IS wedged in the
defrost pan to help
prevent shipping dam­
age This block must
be removed to clear
the way for defrost
water,
evaporation
and to make the
power cord acces­
sible.
1 Allow 3 inches 1 7 5 cm) between overhead cab­
nets and the refrigerator top
2 Allow at least an inch [2 5 cm) between the refrig­
erator conaenser and the wal
3 You don't need space between counters and
cabinets and *ne refrigerator sides. For ease of
installation, you might want to leave enough room
i’.-’ inch - 'l,2f' cm) so the retrigerator can be
moved easily
4 If the refrigerateis to De against a wall, you might
want to leave enough space so the door can be
opened wider
Level refrigerator-freezer...
Keep the 4 bolts that hold refrigerator In shipping
crate. They are the levelling legs
Screw these bolts all the way into bolt holes at the
bottom comers of refrigerator Move refrigerata
nto place
3. Adjust each leg until the refrigerator won't rock.
4, Adjust front legs to level the refrigerator.
— To raise corners, turn legs clockwise.
— To lower corners, turn legs counterclockwise.
6. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing aicohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN­
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refrigerator
before using it.
See cleaning instructions
on page 7
Plug it in.
3-prong
grounding type v
wall receptacle
Power Cord
Recommended
Grounding Method
A 115 Volt, 60 Hz , AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired, It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep­
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require­
ments and grounding instruction sheet in your liter­
ature package