Install properly, Level freezer, Remove sales labels – Whirlpool EVISHEXP User Manual

Page 4: Plug it in, Recommended grounding method, Install properly level freezer remove sales labels, Clean it

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Install properly...

Check the strength of the floor It should hold the
weight of a fully loaded freezer

2

Pick a safe place, indoors, away from in­

flammables such as gasoline.

3 Allow 3 inches (7,5 cm) air space on top of freezer

for proper ventilation.

4 Allow at least an inch (2,5 cm) between the

freezer condenser, on the back of the unit, and
the wall

5 Allow*/, inch (1 25 cm) on each side of the freezer

for ease of installation

6, If the freezer is to be in a corner, you might want to

leave extra space on the hinge side so the door

can be opened wider.

Level freezer...

so the door will stay open at any position.

This freezer has 2 threaded leveling legs that are

shipped in a separate package,

1. Screw these legs all the way into bolt holes In the

bottom front corners of the freezer,

2. Slide the freezer into place.
3. Adjust front legs to level the freezer,

- To raise front, turn legs counterclockwise.
- To lower front, turn legs clockwise.

4. Check with level
5. After freezer is fully loaded, recheck with level.

Remove sales labels...

Remove the Consumer Buy Guide label and any

inside

labels before using the freezer.

To remove any remaining giue:

1 Rub briskly with thumb to make a ball, then

remove

OR

2. Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be^
fore removing glue as described in step 1

DO NOT USE rubbing alcohoi or fiammable or

toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the

surtace finish.

NOTE: DO NOT REMOVE the Tech Sheet fas­

tened under the freezer at the front.

Clean it...

Clean your freezer before

using it See cleaning

instructions on page 7,

Plug it in...

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is required.

It is recommended that a separate circuit sen/ing only

this appliance be provided.

Use a receptacie

which cannot be turned off with a switch or puli
chain. Do not use an extension cord.

Attach retaining clip over power cord plug from

literature package inside the freezer.

Advertising