To replace signal light – Whirlpool EW190FX User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
To replace signal light:
The signal light automatically warns of any
unexpected power failure.
If the signal light is not glowing, immediately
check for power interruption, an unplugged power
cord or a burned out signal light.
1. Disconnect freezer from power supply.
2.
Open the freezer door.
3. Push out signal light from behind, then
unplug burned out light. Replace with a
new one. Signal light can be ordered from
your Whirlpool dealer, Part No. 1103639.
4.
Close freezer door and reconnect power supply.
Advertising