Whirlpool EV130C - Manual (Page 4)

Install properly..
1. Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a «Ole ploce, Indoors, away from In­
flammables such as gasoline.
3. Allow 3 inches [7.5 cm) air space on top of freezer
for proper ventilation.
4. Allow at least an inch (2.5 cm) between the
freezer condenser, on the back of the unit, and
the wall.
5. Allow '/2 inch (1.25 cm) on each side of the freezer
for ease of installatipn.
6. If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
7. The four bolts that held your freezer in the shipping
crate are designed to be the levelling legs. Screw
the legs far enough info fhe bolf holes, in each of
the four bottom corners, so the freezer stands
about 1 inch (2.5 cm) off the floor.
1. Keep the 4 bolts that hold freezer in shipping crate.
They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of freezer. Move freezer into place.
3. Adjust each leg until the freezer won't rock.
4. Adjust front legs to level the freezer.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
5. Check with level.
Remove sales labels
Remove the Consumer Buy Guide label and any
Inside labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet tas-
tened under the treezer at the front.
Plug it in...
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep­
tacle which cannot be turned off with a switch
or pull chain. See Individual electrical require­
ments and grounding instruction sheet in your liter­
ature package.