Whirlpool EEV 202X - Manual (Page 4)

4. Placepansofhotwaterinside
freezer to haster^ melting of
frost. Leave door open. As
ice softens and melts, it can
be removed in large pieces.
Direct air from an electric fan
into the freezer to speed
defrosting.
5. Remove drain cap from in­
side bottom of freezer. Re­
move the base grille by
opening the freezer door
and lifting up on two tabs
that extend through the gril
at either end. Pull grille for­
ward and lift off bottom
supports.
Unclip hose and
allow defrost waterto drain
through the hose into a flat
pan. After defrosting and
cleaning, hook drain hose in
place and replace the base
grille and drain cap.
6. Wash inside of freezer with a
solution of 2 tablespoons of
baking soda to one quart of
warm water. Rinse and dry.
Wash the gasket strip around
the door with warm, soapy
water. Rinse and dry.
7. Wash outside of freezer with
warm water, using a mild
soap or mild detergent. Rinse
and dry. Do not use an
abrasive or harsh cleanser.
Waxing is not recommended.
8. Clean condenser located
behind the base grille with a
stiff brush or with the dusting
attachment from your
vacuum cleaner.
return cold control to original
setting. Check to see that
the signal light glows. Return
food to the freezer.
NOTE:
Cleaning waxes, con­
centrated detergents, bleaches
and cleansers containing
petroleum products
should not
be used to clean door gasket or
plastic parts of the freezer.
Replacing
interior light
Disconnect electric cord from
outlet. Remove light shield by
pulling away from the side
wall. To replace, insert tabs in­
to opening in freezer side wall
and press. Replace bulb with no
largerthan a 40-watt appliance
bulb. Reconnect freezer.
4
.