Whirlpool EV0G0F - Manual (Page 4)

Install properly...
1. Check the strength of the floor It should hold the
weight of a fully loaded freezer
2
,
Pick a safe place, indoors, away from inflam­
mables such as gasoline.
Spacers are packed in the freezer. Install them as
shown to keep freezer at least 2 inches [5 cm) from
the wall
Remove the shipping block.
Allow at least 3 inches (7,5 cm] air space on top
and each side of the freezer.
Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level freezer...
1, Slide freezer into place,
2, Level freezer using wood shims sofhat door wil
open at any position.
stay
Remove sales labels...
Remove any labels before using the freezer.
To remove any remaining glue:
1, Rub briskly with thumb to moke a ball, then
remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
foxic solvenfs, such as acefone, gasoline, car­
bon fefrachloride, efc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet on the
back of the cabinet.
Plug it in...
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord. See individual "Electrical Requirements and
Grounding Instructions” provided with your
product.
Attach retaining clip over power cord plug from
literature package inside the freezer.