Install properly, Remove sales labels, Level freezer – Whirlpool EVIIOCXR User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Install properly...

1. Check the strength of the floor. It should hold the

weight of a fully loaded freezer,

2 Pick a safe place, Indoors, away from In­

flammables such as gasoline.

3, Allow 3 inches (7,5 cm] air space on top of freezer

for proper ventilation,

4, Allow at least an inch (2,5 cm) between the

freezer condenser, on the back of the unit, and
the wall,

5, Allow

'/2

inch (1,25 cm) on each side of the freezer

for ease of installation,

6, If the freezer is to be against a wall, you might

want to leave extra space on the hinge side so the
door can be opened wider

7, The four bolts that held your freezer in the shipping

crate are designed to be the levelling legs. Screw

the legs far enough into the bolt holes, in each of

the four bottom oorners, so the freezer stands
about 1 inch (2,5 cm) off the floor.

Level freezer...

so the door will stay

open at any position.

Levelling Leg

Lower

Raise

Start adjustment with the door hinge side.

1, Slide freezer into place,

2, Adjust front legs to level the freezer,

- To raise front, turn each leg clockwise,
- To lower front, turn each leg counter-clockwise,

3, Check with level,
4, After freezer is fully loaded, recheck with level,

4

Remove sales labels...

Remove the Consumer Buy Guide label and any

inside labels before using the freezer.
To remove any remaining glue:

1, Rub briskly with thumb to make a ball, then

remove,

OR
2, Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1,

DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car­

bon tetrachloride, etc. These can damage the
material.

NOTE: DO NOT REMOVE the Tech Sheet fas­

tened under the freezer at the front.

3-prong grounding

type wall receptacle

Freezer

Power Plug

3-prong

grounding plug

Recommended Grounding Method

A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused

and properly grounded electrioal supply is re­
quired, It is recommended that a separate cirouit
serving only this applianoe be provided.

Do not use an extension cord. Use

a recep­

tacle which cannot be turned off with a switch
or pull chain. See individual electrical require­

ments and grounding instruction sheet in your liter­
ature package.

Advertising