Install properly, Level freezer, Remove sales labels – Whirlpool EV190E User Manual
Page 4: Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
1 Check the strength of the floor. It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in
flammables such as gasoline.
3, Allow 3 inches (7 5 cm) airspace on top of freezer
for proper ventilation
4, Allow at least an inoh (2,5 cm) between the
freezer condenser, on the back of the unit, and
the wall
5, Allow inch [1 25 cm) on each side of the freezer
for ease of ir stallation
6 If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level freezer...
so the door will stay open at any position.
This freezer has 2 threaded leveling legs that are
shipped in a separate package.
Screw these legs all the way into bolt holes in the
bottom front corners of the freezer
Slide the freezer into place.
Adjust front legs to level the freezer
- To raise front, turn legs clockwise.
- To lower front, turn legs counterclockwise.
4. Check with level.
5. After freezer is fully loaded, recheck with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1. Rub briskly with thumb to make a bail, then
remove
OR
2, Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE. DO NOT REMOVE the Tech Sheet fas
tened under the freezer at the front.
Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer
Power Plug
3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It Is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with
a
switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.