Install properly, Level refrigerator-freezer, Remove sales labels – Whirlpool EL13SC User Manual
Page 4: Clean it, Plug it in, Recommended grounding method
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
1. Allow 3 inches (7.5 cm) between overhead cab
inets and the refrigerator top.
2.
Allow at least an inch [2.5 cm) between the re
frigerator condenser on the back and the wall
3.
Allow V
'2
inch (1.25 cm) on each side of the re
frigerator for ease of installation.
4.
If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
Level refrigerator-freezer...
1.
Keep the 4 bolts that held refrigerator in ship
ping crate. They are the levelling iegs.
2.
Screw these bolts all the way into bolts holes at
the bottom corners of refrigerator.
3.
Adjust each leg until the refrigerator won't rock.
Slide retrigerator into place.
4.
Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
5.
Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re
frigerator To remove any remaining glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2.
Soak
area
with
liquid
hand
dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN
STRUCTIONS LABELS INSIDE YOUR REFRIGER
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refrigerator before plugging it in or
using it. See cleaning instructions on page 7.
Plug it in...
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere tused
and
properly
grounded
electrical
supply
is
required. It is recommended that a separate cir
cuit serving only this appliance be provided.
Do not use an extension cord. Use
a
recepta
cle which cannot be turned off with
a
switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
• Move Run Switch to RUN.
NOTE: The refrigerator motor will not operate
until the Run Switch is on RUN.