Whirlpool EHISOCXL - Manual (Page 2)

Before you plug it in
Before using your freezer, you are personally
responsible for making sure that it...
• is installed and leveled on a tioor that will
hold the weight, and in an area suitable for
its size and use.
• is connected only to the right kind of outlet,
with the right electrical supply and ground­
ing. (Refer to your “Electrical Requirements
and Grounding Instructions.")
• is used only for jobs expected of home
freezers.
• is not near an oven, radiator or other heat
source.
• is properly maintained.
• is in a dry sheltered area.
• is used in an area where the room tempera­
ture will not exceed 110°F, (43.3 C).
• is not run where there are explosive fumes.
• is not used by children or others who may not
understand how it should be used.
• is not loaded with food before it has time to
get properly cold.
Install Properly...
Allow room to open lid
2 ine hes c
’Vi
it bo
L
:k
___
3 inches 3 inches
1. Check the strength of the floor. It should hold
weight of fully loaded freezer.
2. Allow at least 3 inches (7.5 cm) air space on
all sides of freezer and 2 inches (5 cm) at
back. Leave room at top for lid to open all the
way.
3. It should not be necessary to remove the lid
during installation. If, for any reason, the hinges
need
adjustment, see your authorized
WHIRLPOOL dealer.
4. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level Chest Freezer,..
from end to end and frontto back sothatthe lid
will seal properly.
Remove the Consumer Buy Guide label before
using the freezer. Remove any left over glue with
rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser­
vice label on the inside lid. This permanent
label
provides immediate information
should it be needed. Do not remove Tech
Sheet permanently attached to inside of
service panel.
Clean It...
Clean your freezer before using it. See clean­
ing instructions on page 4.
Defrost Drain Cover...
Installing Defrost Drain Cover:
1. Remove cover from literature package.
2. Check drawing on page one tor placement.
3. Install cover.