Whirlpool 3366859 - Manual (Page 6)

OPERATING YOUR WASHER
5. Turn the Load Size Selector to the
setting that corresponds with the size
of the wash load and the type of fabric
being washed.
(See pages 12-13.)
• Select any of five load sizes: Extra
Small, Small, Medium, Large, and Extra
Large.
• To change the load size setting after the
washer has started to fill, turn the
Selector to the desired new setting.
6. Turn the Water Temperature Selector
to the setting that corresponds with
the type of fabric and soils being
washed.
• Select any of four wash-rinse water
temperature combinations: hot-warm,
hot-cold, warm-cold, and cold-cold.
• The top temperature is the wash water
and the bottom temperature is the rinse
water.
• See page 14 for water temperature
guidelines.
7. (OPTIONAL STEP) If desired, set the
Extra Rinse Selector to On to add an
additional rinse to the end of the
wash cycle.
• Use the extra rinse option when using
extra detergent for the Super Wash cycle
or for the Heavy, Permanent Press, or
Knits/Gentle cycles. Extra rinse option is
not offered in the Regular cycle.
• Before a cycle starts, select Extra Rinse
On. The washer automatically adds an
extra rinse and spin to the cycle.
• If you do not want an extra rinse and
spin, or if you are using the Regular
cycle, select Extra Rinse Off.
8. Push in and turn the Cycle Control
Knob clockwise. Stop when the indica­
tor on the outer ring points to the
number in the wash cycle you want.
• The numbers are minutes of wash time.
• The cycles are described on pages 7-8.