Adjusting the refrigerator shelves, Removing the crisper, trivet and crisper cover, Changing the light bulb – Whirlpool ETl8SC User Manual

Page 6: Ice cube trays

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Adjusting the refrigerator shelves...

1 First, remove food from shelf,
2, Slide shelf straight out to stop,

3 Lift front,
4, Slide the rest of the way out

Guide Stop

Shelf Stop

Replacing Shelf:

1, Fit back of shelf on top of guides with wire stops

on the bottom of guides

2 Lift front, slide shelf in until it clears guide stops

Shelf Guide

Removing the crisper, trivet and

crisper cover...

Removing crisper:

1, Slide crisper straight out to stop,

2, Lift the front,
3, Slide the rest of the way out,
4, Replace in reverse order.

Removing trivet:

1, Lift the trivet from the support brackets on the back

wall,

2, Replace in reverse order

Removing cover:

1, Lift front, then lift back,

2, Pull up and out.

Replacing cover:
1, Fit notches on back of cover into supports on back

wall of refrigerator,

2, Lower front into place.

Changing the light bulb...

WARNING: Before removing the iight buib, either

unpiug the refrigerator or disconnect
the electricity leading to the re­
frigerator at the main power supply.

Shock and injury can occur if eiec-
tricity remains connected.

1, Reach behind control console to find bulb
2 Remove bulb
3, Replace with a 40-watt appliance buib.

Lift the Front, Then the Bock.

Pull Out to Stop.

Lift the Front and Pull Again.

Ice cube trays...

To remove ice:

1, Flold tray at both ends.

2. Slightly twist.

If cubes are not used, they may shrink. The moving

cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.

Advertising