Whirlpool EH23EFX - Manual (Page 4)

Install properly...
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in­
flammables such as gasoline.
3, Allow at least 3 inches (7,5 cm) air space on all
sides of freezer and 2 inches (5 cm) at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad­
justment, see your authorized WHIRLPOOL dealer.
5 Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level ehest freezer...
from end to end and front to back so that the lid will
seal properly.
Check with level
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2, Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Care & Service label
on inside lid or Tech Sheet on back of cabinet.
Install defrost drain cover...
1, Remove cover from literature package,
2, Check drawing on front cover for placement,
3, Install cover
Plug it in...
3-prong grounding
type wall receptacle
Freezer
Power Plug 3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep­
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require­
ments and grounding instruction sheet in your liter­
ature package.