Citizen Systems CLP-6401 - Manual (Page 81)

6-18
･ Initialization parameter values
Initialization values for print or cut position are described below by each
operating mode.
In Native ON Unit: mm (inch)
Normal
print
Auto- cutter Peeling Tear-off
Minimum
value
Print position
(Onnnn, form
offset)
55.9 (2.2)
55.9 (2.2) 55.9 (2.2) 55.9 (2.2)
12.7 (0.5)
Cut position (fnnn,
feed offset) 55.9 (2.2) 86.4
(3.4)
68.6
(2.7)
73.7
(2.9)
12.7
(0.5)
If value lower than the minimum value is set, the initialization value will be set
automatically.
6.5.6 When "fnnn" command is executed while Tear is OFF
Even with the tear-off OFF, the paper will be fed to the "fnnn"-specified position
after printing if an "fnnn > Onnnn" value is set by using the "fnnn" command.
This function can be used in such cases as another device is incorporated in the
printer.
6.5.7 Priority order
The following three functions (optional) cannot be performed simultaneously.
If commands for those three functions are received simultaneously, they will be
executed in the following priority:
1st: Auto-cutting
2nd: Peeling
3rd: Tear-off