COBY electronic TF-DVD7060 - Manual (Page 14)

14
Remote Control
Refer to the diagram. Remove the battery
compartment cover located on the rear of the
remote control. Insert batteries, making sure
to match their polarities (+/-) to the markings
on the inside of the compartment. Replace
the cover.
To use the remote, point it at the remote sen-
sor of the player. Operate the remote within
15 feet of the sensor and at an angle of +/- 60
degrees.
Batteries in the remote will last for approxi-
mately 1 year. Replace the batteries if the
remote control does not work. Do not mix
old with new batteries, or different types of
batteries.
Remove the batteries from the remote if it will
not be used for a long period of time.
WARNING
The battery used in this device may present a fire or chemical burn if mistreated. Do not
recharge, disassemble, incinerate, or heat the battery (~212ºF).
Keep batteries away from children.
Power Supply
Using the AC Power Adapter
This AC adapter should be used with
100-240V 50/60Hz AC wall outlets.
DC Out: 9V
DC Current: 2.0A min.
Caution:
Do not connect the power plug
to a power outlet other than that
which is indicated here and on
the label as this may result in the
risk of fire or electric shock.
Do not handle the power plug with wet hands. Doing so may cause electric shock.
Only use AC adapters of the type specified here. Failure to do so may case a fire or damage
the player.
•
•
•
•
•
•
•
•
•
•
•
GETTING STARTED
2 x “AAA” 1.5V batteries
To DC 9V IN
To wall outlet
(100-240V 50/60Hz)
AC adapter:
This AC adapter operates on
100-240V~~50/60Hz 2A Min
DC OUT: 9V
DC current: 2.0A Min