Care and cleahm remavahle parts – Kenmore 911.46565 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

KGnm€^r&

CARE AND CLEAHm

Remavahle Parts

LIFT UP COOKTO

I* Grasp the edge of the cooktop and

lift up,

2. Holding the cooktop with one

hand, lift the support rod up and
rest the edge of the cooktop on it.

3. When cleaning is finished, lower

the support rod and the cooktop.

CAUTIONS When
working in this area, be

careful not to bump Into the
support rod(s). The porcelain

enamel surface of the
cooktop can chip if droppecl.

REMOVABLE COOKTOP UNIT

Element

Drip Bowls

TO REMOVE

Receptacle

Be sure the controls are in the off

position and the elements are cool
before attempting to remove them.

Grasp the element and lift slightly,

just enough to clear the drip bowl

and puli it straight out.

CAUTION: Ob hot lift

^ ;thO:^''element-more than

1 “. Lifting the element more

than T. can damage ^ the-' -' ^

receptacle, causing the

element not to lie flat when
it is plugged bach In. -

-'

Lift but the drip bowl.

TO CLEAN THE ORIP BOWL
For brown food stains
- Use
dishwashing detergent, warrm water,
plastic scouring pads, mild abrasive

cleaners, soap-filled scouring pads
or ammonia, Clean drip bowls after
each use. Rinse and dry well. Fdods

that are not removed can

permanent stains that cannot be
removed. For heavily soiled bowls,
place an ammonia-soaked paper

towel over the bowl to loosen the soil,

then gently scrub the bowl with a

plastic scouring pad.

For blue-gold heat stains Use

a metal polish. These stains are
caused by overheating, and are
usually permanent. To help minimize

this effect, avoid excessive use of
high heat settings and use flat bottom
pans that do not extend more than 1"

from the edge of the cooking element.

CAUTION: Donor

operate the cooktop

elemehts without the drip
bowl in place. Scorching of

the cooktop, burning of

wiring insulation and loss of
energy will occur.

TO REPLACE THE UNIT

1

2.

Place the drip bowl into the
opening and make sure the
receptacle is visible.

Slide the element firmly back into

the receptacle and lower it onto
the drip bowl.

2S

Advertising
This manual is related to the following products: