Kenmore 385.11607 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE THE MACHINE FOR SEWING
Prepare the Bobbin
• To Remove the Bobbin Case from the Machine
the
machine
by
pulling
it
to
the
left.
Open
the
shuttle
cover
by
pulling
down
the
embossed
part
on
the left side of the cover.
Raise
needle
to
its
highest
position
by rotating hand wheel toward you.
shuttle.
Wind the Bobbin
tie, pull open latch of bobbin case.
Pull bobbin case straight out of
moving
bobbin.
while you wind the
NOTE:
The
bobbin
winder
stopper
can
be
adjusted
for
the
amount
of
thread
needed
on the bobbin (example 1/ 2 full or full etc.). To make the adjustment use
your large screw driver and loosen the screw one turn or less. This will allow
you
to
adjust
the
position
of
bobbin
winder
stopper.
Do
not
take
screw
all
the wayout.