Kenmore 665.15622 - Manual (Page 7)

r];,:rf 'S^'
The ULTRA WASH soil removal system gives you sparkling clean
dishes, while using less energy and time. The ULTRA WASH soil
removal system includes:
A heavy-duty grinder that acts as a food disposer to grind and
dispose of large food particles.
How the ULTRA WASH soil removal system works
1. Load the dishwasher. Remove bones, large chunks or
burned-on food. No rinsing is necessary. Any remaining food
soil will be ground up and disposed down the drain with the
rinse water.
2. Hot water fills the dishwasher to a level near the bottom of
the overfill protection float.
3. The Heating indicator glows and the dishwasher pauses while
the water is heated.
4. When the water reaches the proper temperature, the Heating
indicator turns off and the cycle countdown resumes.
5. Detergent from the detergent dispenser is dispensed at the
correct cycle times and hot water is pumped through the
ULTRA WASH pump.
6. Hot water and detergent sprays against the soiled surfaces of
the load and removes food particles.
7. Food soil is held in an accumulating chamber.
START-UP GUIDE
Before using your dishwasher, remove all hang tags, temporary
labels, and packaging materials. Read this entire Use and Care
Guide, You will find important safety information and useful
operating tips.
1 .
2 .
Scrape large food soil and hard items (toothpicks or bones)
from dishes.
Properly load the dishwasher. (See “Loading Your
Dishwasher") Make sure nothing prevents the spray arm(s)
from spinning freely.
3. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See “Using Your Dishwasher.”)
8. Food soil is disposed down the drain with the wash water.
4.
9. Fresh, hot water enters the dishwasher and sprays on the
dishes. The rinse water is then pumped through the
ULTRA WASH soil removal system and remaining soil
is removed.
10. The food soil that is held in the ULTRA WASH soil removal
system is disposed down the drain with the rinse water.
11 . The final rinse water is heated. The rinse aid is added to the
water for the final rinse to prepare the dishes for drying.
Push door firmly closed. The door latches automatically. Run
hot water at the sink nearest your dishwasher until the water
is hot. (See “Dishwasher Efficiency Tips.”) Turn off water.
5. Press the desired cycle and option selections. (See “Using
Your Dishwasher") Turn the Cycle Control knob to the desired
cycle to start.