Kenmore ELITE 790.428 - Manual (Page 10)

Setting Cooktop Controls
To Turn ON one or more of the Cooking Zones (cont’d)
IMPORTANT OPERATING NOTES:
® Fluids spilled or objects lying on the controls area of the cooktop may cause the cooktop to turn OFF while cooking.
Clean the spills or remove the objects from the cooktop.
® Be sure the cooktop vent holes are NOT blocked. If the vent holes are blocked the cooktop internal sensor may shut
OFF of the cooktop to avoid over heating the appliance.
• If the cookware or pan is moved from the center of any active Cooking Zone for any reason, a sensor will detect the
situation and the cookware will no longer heat. The affected Cooking Zone LED will flash between Fand the last
power level set for the Cooking Zone. The Cooking Zone will remember the power level setting for up to 3 minutes
before the Cooking Zone will automatically shut OFF. If the cookware is brought back properly centered o
To Turn OFF the Cooking Zones:
1. Once cooking is complete, touch the wm key pad to turn the Cooking Zone OFF.
The corresponding Cooking Zone ON/OFF Indicator light located above the key pad will turn OFF. A beep will
sound and the chosen Cooking Zone power level LED will display 0. If no other key pads are touched the Cooking Zone
will shut OFF automatically in 5 seconds. If no other Cooking Zones are active and no other key pads are touched the
entire cooktop will shut OFF automatically in 5 more seconds.
When any Cooking Zone is OFF, the corresponding Cooking Zone LED may display H if the Cooking Zone temperature
is too HOT. The LED will continue to display H, and even if the Cooktop is switched OFF the LED will continue to
display Has long as the cooktop remains HOT.
^CAUTION I The Cooking Zones may appear to be cool while turned ON and after they have been turned OFF. The
glass surface may be HOT from residual heat transfered from the cookware and burns may occur.
Preheat Recommendations
When preheating a pan on the cooktop always watch carefully. Whenever using the cooktop the user should always pay
attention to any items cooking and remain attentive until the cooking process is complete.
Keep in mind that induction may decrease the amount of time required to preheat a cooking utensil.
Keep Warm Feature
The Warm feature may be used with any of the Cooking Zones.
To Turn the Keep Warm Feature ON:
1. To select the Keep Warm feature for any Cooking Zone touch the WN/oifl key pad for the corresponding Cooking Zone.
Touch the key pad located in the main control area. The Cooking Zone will display L (LOW) indicating that the
Cooking Zone is properly set to Keep Warm. If no other key pads are pressed for a period of 5 seconds the control will
activate the desired Cooking Zone at the Keep Warm setting (See Fig. 16).
1 0