Operating your coffeemaker, Operating the control panel – Kenmore ELITE 100.90006 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR COFFEEMAKER
6. Turn on the coffeemaker by pushing in the BREW ON/OFF button. The ON/OFF
button will illuminate blue and the word Brew will show up in the control panel display
showing that the coffeemaker is brewing. In a few seconds, hot water flows into the
filter. When the water has stopped flowing, the coffeemaker automatically switches
to the warming mode. For delayed brewing, see SETTING THE CLOCK, TIMER AND
AUTO-BREWING.
7. When you have poured out all the coffee in the carafe, press the BREW ON/OFF
button to turn off the appliance, and remove the carafe from the warming plate.
NOTE: If the coffeemaker is not turned off, it will automatically shut itself off
after two
hours.
PAUSE AND POUR FEATURE
The pause and pour feature enables you to remove the carafe from the Coffeemaker
and pour a cup of coffee before brewing is finished. When the carafe is removed,
a special valve stops the flow of coffee from the brew basket to the carafe. Brewing does
not stop. If the carafe Is not replaced under the brew basket after 20 seconds, water and
coffee will overflow from the brew basket.
OPERATING THE CONTROL PANEL
SETTINGTHE CLOCK,TIMER AND AUTO-BREWING
USE THE Set Clock Button TO SET THE CLOCK:
1. Press Set Clock button and the button’s indicator light will flash.
2. Set the time of day by pressing the Hour and Minute buttons. Be sure to set the time
with the correct AM and PM designation.
3. You can make the hours and minutes move more quickly in the clock display by
holding the buttons down.
4.
if you press the Set Clock button and don’t do anything for 5 seconds, the button’s
light flashes 5 times then turns off. To resume, press the Set Clock button again.
The clock starts a few seconds after you finish setting it.
SET THE Set Auto Button TO PROGRAM IN A BREW TIME:
1. First set the clock. See directions above.
2. Press the Set Auto button and the button’s indicator light will flash.
3. Set the time you wish the coffeemaker to begin brewing by pressing the Hour and
Minute buttons. Be sure to set the correct designation of AM or PM.
4. You can make the hours and minutes move more quickly in the clock display
by holding the buttons down.