Kenmore 580.75281 - Manual (Page 12)

OPERATION
REMOTE CONTROL
NOTE: The Remote Control will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER -----------------------------------------------------------------------------
• To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the air conditioner is on the High cool mode and the Temp, at 72“F
• Auto restart
In the event as a power failure, the unit will run at the previous setting once power returns.
TEMPERATURE SETTING---------------------------------------------------
• Use this button to automatically control the temperature of the room.
The temperature can be set within a range of 60°F to 86“F by increments of 1°F.
* The setting appears in the display.
FAN SPEED------------------------------------------------------------------
• Every time you push this button it advances the setting as follows:
(High ► Low ► Med ► High)
TIMER------------------------------------------------------------------------------
• You will usually use shut-off time while you sleep.
• If unit is running, usetimer to set number of hours until shut-otf.
• For your sleeping comfort, once timer is set, the thmperature
setting will raige 2°F after 30min and once again after another 30min.
• Push timer button to advance setting from 1 Hour + 2Hour........... »12 Hours maximum.
-START TIME
• If unit is oft, Timer sets number of hours before unit starts.
• Push timer button to advance setting from 1 Hour * 2Hour............ »12 Hours maximum.
MODE ------------------------------------------------------------------------------------------------
- Push this button to shift mode of operation from cool + energy saver + fan.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on so that the unit
can check the room air to determine if cooling is needed.
HOW TO INSERT BATTERIES INTO REMOTE CONTROL
1. Remove the cover from the back of the remote
controller.
• Open the cover according to the arrow direction on the
cover.
nsert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
2 .
• Do not use rechargeable batteries.
Such batteries differ from standard dry cells in shape,
dimensions, and performance.
• Remove the batteries from the remote controller if the air
conditioner is not going to be used for an extended
length of time.
• The remote control can be mounted on a wail using the
mountable holder.
i
M if
II