Operation, Control panel – Kenmore 580.53701 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

• 9Mi,anjM

rittr

4SBk

W

w

HUMORV-,,

•:.••-• -.crtmwi;-

:

Aucicer

.

pmx

CONTROL PANEL

Your dehumidifier control pane! contains a Bucket Full indicator, a Humidity indicator, a Power
Control, Humidity Control, Fan Speed Contiol and Timer Control.

Bucket Full indicator

—This light glows when the water bucket is full and needs to be emptied.

It also glows vriien №e bucket is not property positioned.

Power

-- Operation starts when this button is pressed and stops when the button is pressed again.

Humidity Control

~ This button conbols the hurr^ity in the room.

9

: To raise the humidity setting

• • : To lower the humidity setdng
• The hurrtdity can be set within a range of 35%-70% RH( Relative Humidity) by 5%

increments.

• If you push « button once again at 35% RH,

on is displayed and Unit operates without RH.

Fan

Speed

— This controls the speed of the airflow.

• When Fan Speed button is pressed, the fan speed mode changes from High Low -*■ High.

Energy Timer

— Press this button to select type of operation.

• Select Constant for unintemjpted operation.
• Select either 3 or 6 Hr. On/Off for cycled operation.

The unit will operate for 3 or 6 hours, and then shut off oonpletely for 3 or 6 hours.
The cycle repeats until you change the setting.

• When Energy Timer button is pressed, the Timer indicator lights shift as follows:

Continuous On-* 3 Hr. On/Off 6 Hr. On/Oft -♦ Continuous On

Auto

Restart— Once power is restored after a power outage, the unft begins operating at tts previous

operation settings after a 2 minute delay.

TO OPERATE THE DEHUMIDIFIER:

1. Plug the power cord into an electrical outlet. Press the power button.

2. Set the Humidity Control anywhere between 35%-70% RH(ReIative Humidity for normal operation.

If you need drier air, press the • Hurrtidity Control button.
If you need moister air, press the • Humidity Control button.

3. Press the Power button to stop the unit manually.

4. Press the Timer button to set the amount of time you want the unit to am.

At ttie end of that time, the unit will shut off.
The Timer can be set for: Continuous On, 6 hours or 3 hours.

5. If you vrant to control ttie speed of airflow, press Fan Speed button. Earii time that the Fan Speed button

is pressed, the fan speed mode is shifted: High -* Low -* High

Note; Be careftil not to lose the water bucket.

nils dehumidifier doesn't mn If the water bucket Is not installed properly.

-6

Advertising
This manual is related to the following products: