Suggested pile height settings, Performance features, Overload protector – Kenmore 116.28615 User Manual

Page 13: Edge cleaner, Warning, Performance indicator

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SUGGESTED PILE HEIGHT SETTINGS

For best deep down cleaning, use the

XLO

setting. However, you may need to raise the
height to make some jobs easier, such as
scatter rugs and some deep pile carpets,
and to prevent the vacuum cleaner from
shutting off. Suggested settings are:

HI - Shag, deep pile, or scatter rugs.

MED “ Medium to deep pile.

LO - Low to medium pile

XLO “ Most carpets and bare floors.

PERFORMANCE FEATURES

Overload

Protector/

Beit Reset Button^

OVERLOAD PROTECTOR

The PowerMate has

built-in protection

against motor and

belt damage should

the agitator jam. If

the agitator slows
down or stops, the
overload protector
shuts off the PowerMate. The canister motor
will continue to run.

To correct problem: Turn off and unplug

vacuum cleaner, remove obstruction, then
press

BELT RESET button. A ball point

pen may be required.

ff the problem persists, have the

vacuum cleaner serviced by a Sears or

other qualified service agent.

EDGE CLEANER

Active brush edge

cleaners are on both
sides of the
PowerMate. Guide
either side of the

PowerMate along

base-boards or next to
furniture to help

remove dirt trapped at

carpet edges.

WARNING

Personal Injury Hazard

Always turn off and unplug the
vacuum cleaner before cleaning the
agitator area as agitator may
suddenly restart. Failure to do so

can result in persona! injury.

PERFORMANCE INDICATOR

Performance

Indicator

When the vacuum

cleaner is running

with norma! airflow,

the light on the
performance
indicator is off. The
light comes on

whenever the

airflow becomes blocked. If that occurs,
check the disposable dust bag, motor
safety filter and other possible clog

locations shown in

HOW YOUR VACUUM

CLEANER WORKS.

To correct problem: See the TROUBLE­

SHOOTING table

NOTE: The light may come on when using
certain attachments, due to reduced airflow
through attachment.

13

Advertising
This manual is related to the following products: