FRIGIDAIRE FFPS4533QM - Manual (Page 4)

INSTALLATION ENERGY SAVING TIPS
This Use & Care Guide provides general operating
instructions for your model. Use the refrigerator only as
instructed in this Use & Care Guide. Before starting the
refrigerator, follow these important first steps.
Location
• Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug.
• For the most efficient operation, the refrigerator
should be located where surrounding temperatures
will not drop below 50°F (10°C) or exceed 110°F
(43°C).
• Allow space around the unit for good air circulation.
Leave a 4 inch (101.6 mm) space on the back and 3
inches (76.2 mm) on the sides and back of the
refrigerator for adequate circulation.
NOTE
The exterior walls of the refrigerator may become
quite warm as the compressor works to transfer heat
from the inside. Temperatures as much as 30°F (-1°C)
warmer than room temperature can be expected. For
this reason it is particularly important in hotter climates
to allow enough space for air circulation around your
refrigerator:
Leveling
The refrigerator must have all bottom corners resting
firmly on solid floor. The floor must be strong enough
to support a fully loaded refrigerator: NOTE: It is Very
Important for your refrigerator to be level in order to
function properly. If the refrigerator is not leveled during
installation, the door may be misaligned and not close
or seal properly, causing cooling, frost, or moisture
problems.
To Level Your Refrigerator:
After removing all interior and exterior packaging
materials, use a carpenter's level to level the refrigerator
from front-to-back. Adjust the plastic leveling feet in
front, Vz bubble higher, so that the door closes easily
when left halfway open.
Cleaning
• Wash any removable parts of the refrigerator
interior, and exterior with mild detergent and warm
water: Wipe dry. Do not use harsh cleaners on these
surfaces.
• Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when
removing adhesive labels. Any glue left from the tape
can be removed with a mixture of warm water and
mild detergent, or touch the residue with the sticky
side of tape already removed. Do not remove the
serial plate.
ENERGY SAVING TIPS
Install the refrigerator in the coolest part of a dry
and ventilated room, out of direct sunlight and away
from heating ducts or registers. Do not place the
refrigerator next to heat-producing appliances such
as a range, oven or dishwasher.
Level the refrigerator so the door closes tightly.
Do not overcrowd the refrigerator or block cold air
vents. Doing so causes the refrigerator to run longer
and use more energy. Shelves should not be lined
with aluminum foil, wax paper or paper toweling.
Liners interfere with cold air circulation, making the
unit less efficient.
Wipe bottles and containers dry before placing them
in the refrigerator. This cuts down on moisture build­
up inside the unit.
Organize the refrigerator to reduce door openings.
Remove as many items as needed at one time and
close the door as soon as possible.