Lower oven general care & cleaning – Kenmore ELITE 790.488 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lower Oven General Care & Cleaning
(continued)
SPECIAL DOOR CARE INSTRUCTIONS
CHANGING LOWER OVEN LIGHTS
IMPORTANT
Most oven doors contain glass that can break. Read the
following recommendations:
•
Do not close the oven door until all the interior oven
racks are fully inserted and retracted to the back of the
oven.
•
Do not hit the glass with pots, pans, or any other object.
The oven door glass may break or even break at
a
later
time unexpectedly.
•
Scratching, hitting, jarring or stressing the oven door
glass may weaken its structure causing an increased risk
of breakage at
a
later time.
•
You may use a glass cleaner on the outside of the oven
door glass. Do not spray or allow water or the cleaner
to enter or drip down into the oven door vents. Spray
cleaner on cloth first and then wipe the oven door clean.
•
Do not use strong oven cleaners, powders or any harsh
abrasive cleaning materials on the outside of the oven
door or glass.
•
Never clean the oven door gasket. The oven door
gasket should always clean during the Self-clean cycle.
ik CAUTION
• Be sure the appliance is unplugged and all parts are
COOL before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass or
burns.
The lower oven light bulbs are located on both side of the
oven cavity and both are covered with
a
glass shield. The
glass shield must be in place whenever the oven is in use.
Replacing the lower oven interior light bulbs:
1. Turn electrical power off at the main source or unplug
the appliance.
2. Remove lower oven interior light shield as illustrated
below.
3. Replace bulb with
a
new T-4 type 40 Watt Halogen
appliance bulb. Please note: do not allow your fingers to
touch the new bulb when replacing. This will shorten the
life of the new bulb. Use
a
paper towel to cover the new
bulb when installing.
4. Replace glass shield over bulb.
5. Turn power back on again at the main source (or plug
the appliance back in).
6
.
The clock will then need to be reset.
V'
Halogen
Light Bulb
■]np<
Lift backside
of glass shield
and remove it.
40