Side burner and back burner lighting instructions – Kenmore 119.16312800 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USE AND CARE INSTRUCTIONS
Grill Lighting Instructions
1
Before each use, check all hoses for cracks,
nicks, cuts, or abrasions. If a hose is
damaged in any way, do not use your grill
before replacing the hose with an authorized
part from the Parts List. Also make sure all
gas supply connections are securely
tightened.
Familiarize yourself with the Safety and Use
and Care instructions in this manual. Do not
smoke while lighting the grill or checking gas
supply connections.
Be sure the LP gas tank has gas.
Open the grill lid.
Back Burner
Electric Igniter
Failure to replace a faulty hose, secure gas
supply connections, or to open the lid before
proceeding to the Lighting Procedures could
result In a fire or explosion that could cause
serious bodily Injury, death, or property damage.
Set control knobs to OFF and open the LP
gas tank valve SLOWLY.
6
.
Push and turn any control knob to Hi
Low
Immediately press the electronic Igniter
button for 3-5 seconds to light the burner.
You should hear a clicking sound which
shows the electronic ignition is working. If
the burner does not light within 5 seconds,
turn the burner control knob to "OFF". Wait 5
minutes for the gas to clear, and repeat the
above procedure.
Once one burner Is lit, the adjacent burner
can be lit by turning Its control knob to Hi.
When lit, turn the control knob to Its desired
setting.
Side Burner and Back Burner Lighting
Instructions
1. Follow steps 1 through 4 of the Grill Lighting
Instructions.
2. Open the grill lid or side burner cover.
3. Set control knobs to OFF and open the LP
gas tank valve SLOWLY
4. Push and turn the control knob to "Hi".
5. Immediately press the electric igniter button
for 3-5 seconds to light the burner. You
should hear a clicking sound which shows
the electronic ignition Is working.
6
.
If the burner does not light within 5 seconds,
turn the burner control knob to "OFF". Wait
5 minutes for the gas to clear, and repeat the
above procedure.
7. Continue to press in and hold the back
burner control knob for 5 to 7 seconds once
lit to activate the safety flame
sensor. Failure to do so will cause gas to be
shut off to the back burner and the burner
will go out.
22