Kenmore 665.16734 - Manual (Page 13)

f
Q uick C
WiNSE J
Use this rinse cycle for Do not use
rinsing dishes, glasses,
detergent
and silverware that will with this
not be washed right away, cycie.
Soil
Level
Sensed
Wash Rinse Main
Wash
Rinse Final
Heated
Rinse
Dry Time
(min) Water
Usage
(gal/L)
Heavy
• • 14 4.3/16.4
Light
• 10 2.2/8.2
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Canceling a Cyd©
/\nytime during a cycle, press
CANCEL/DRAIN glows. The dishwasher pauses for about 5
seconds and starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light goes off when the
dishwasher finishes the drain.
To stop the drain
You can press CANCELyDRAIN again to stop the drain
immediately. Remember to drain the dishwasher before starting a
new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To dear the indicators
Press CANCEiyDRAIN before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first minute of a cycle
Press a new cycle and/or options.
After the first minute of a cycle
1, Press
2 .
3 .
4 .
5 .
GANCEUDRAIN glows. The dishwasher pauses for 5
seconds and starts a 2 minute drain (if needed). Let the
dishwasher drain completely.
Check the detergent dispensers. If the main wash cup has
opened and the detergent washed away, refili the cups as
needed.
Close the door.
Press a new cycle and/or options.
Press START.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the main wash
section is still closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the main wash detergent dispenser is still
closed, add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4 . Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause.
Option Selections
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to use the same cycle and option(s) as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi Temp Scrub
Select this option to heat the water during parts of the cycle. Hi
Temp Scrub heats the water to 145°F (63°C) in the main wash.
Heating the water helps improve washing results-
This option adds heat, water and wash time to the cycle.
\SCRU^
NOTE: Hi Temp Scrub is an option with Pots Pans and Normal
Wash.
Sani Rinse
Select this option to raise the water temperature in the final rinse
to approximately 155°F (68°C) for 10 minutes. Sani Rinse adds
heat and time to the cycle. In the Normal cycle this high-
temperature rinse sanitizes your dishes and glassware in
accordance with the NSF Protocol PI 53 Sanitization and
Cleaning Performance of Household Spray-Type Dishwashers,
NOTE: Sani Rinse is an option with Pots Pans, Normal Wash and
Water Miser.
13