Front lovow vsnfc:r – FRIGIDAIRE 5303937140 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FRONT LOVOW vsnfc:R
PROCEDI RE FOR REPLNCTNG THE BOO I coiumued
! 4 )
1
^)
17
)
Replace ihe hoot e\taision back onto the
duct and pull it up ovei the ndge on the
duct neat the top ot'the opening
Reinstall the clamp in such a way that the
clamp sits between the ridges on the
extrusion and abo\'e the ndge on the duct
Snap the clamp closed with the copper
tubing tool that \’ou used preuously
Before attaching the new boot to the front
panel, clean the suiTace of the front panel
with alcohol or household cleaner Also
clean the flat surface of the new boot that
will be contacting the front panel This
step IS needed to remove the mold release material used in the manufactunng process and will allow
the adhesive to stick
16) Remount the boot onto the front panel as
shown in figure # 1 3 , making sure that
the boot is not wTinkled Iflarge wrinkles
exist, they may pool water in the boot and
dribble onto the floor w hen the door is
opened
[fthis IS the case, pull it loose from the front
pane! and remount it slightly more clockwise
or counter clockwise as needed
ILLUSTRATION# 12
Using the adhesive supplied in the kit,
sparingly apply dots of glue under the edge
of the boot as shown in # 14
Spot glue at the 1 2 o’clock, 1. 2. 3, 4, 5 6,
7, 8 and 9 o'clock positions around the
opening
Caution the consumer to wait a couple of
hours before using the washer to allow the
adhesive enough t i m e t o d r y
ILLUSTRATION# 14
! r l i i i i I I