Door removal instructions – Kenmore 25353222301 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Door Removal Instructions
Hlrge
9s MW ■■■ ■ ■ -A’’-' Cow ■ I
Cover 5crew
№
-I
o
z
LU
1bp Hinge
Cover
Hinge
Screws
„1
i f-i-.. T?
I Ö •
••. 'i ;•• •:
. . . . . I
IbpHinge
Poor
Hinge
Asiembly
Screws
DOOR REMOVAL INSTRUCTIONS:
If it is necessary to move the refrigerator through narrow doorways,
foilow these steps to remove the doors.
IMPORTANT;
Before you begin, turn Freezer and
Fresh
Foot/controls
to “O ” and rem ove electrical power cord from wall outlet. Rem ove any
food from door shelves.
1.
Disconnect electrical supply.
2.
O pen both doors, then rem ove toe grille.
3.
Close doors.
To Remove Refrigerator Door:
1.
Rem ove top hinge cover screw on refrigerator door and rem ove cover.
2.
Trace around hinge with soft lead pencil. This will m ake it easier to realign
doors when they are replaced.
3.
Rem ove top hinge and lift refrigerator door off bottom hinge pin. Set door
aside.
4.
Rem ove bottom hinge, if necessary.
5.
Reverse this procedure to reinstall refrigerator door.
To Remove Freezer Door:
1.
Disconnect water line com ing from lower hinge of freezer door at connection
located under front of freezer: Press outer ring against face of fitting, then pull
to rem ove tube.
2.
Rem ove top hinge cover screw on freezer door and rem ove cover.
3.
Disconnect wiring harness connector plug at top hinge: place your thum bs on
flat sides of each connector and bend both parts back and forth, then with
firm grasp, pull both pieces apart.
Trace around hinge with soft lead pencil. This will m ake it easier to realign
doors when they are replaced.
Rem ove top hinge, allowing wiring harness to pull through hinge and lift freezer
door off of ixittom hinge pin. Lay door dovm flat to avoid kinking water line.
Rem ove bottom hinge, if necessary.
Reverse this procedure to reinstall freezer door.
W hen both doors have been reinstalled, connect water line by inserting tube and
push until m ark touches face of fitting, replace toe grille and plug in electrical power
cord. Turn both tem perature controls to center position. Adjust settings as necessary.