Assembly instructions, Warning, Electrical shock hazard – Kenmore 116.31912 User Manual
Page 5: Handle assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
A
WARNING
Electrical Shock Hazard
Do not plug into the elechical supply
unSI the assembly is complete. Failure
to do so could result in electrical shock
or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
Remove the
tape located
below the dust
cover/filter cover
on the motor
case.
Attach stretch hose
end to nozzle as
shown.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra
tion below.
Slide the handle into the opening at the top
of the vacuum.
Insert the screw so it passes through the
handle into the vacuum.
Begin to tighten the screw with your fingers,
it may be necessary to adjust the handle
slightly.