Crosley Radio Crosley Grand Music Center CR67 - Manual (Page 2)

POWER SOURCE
Unwind the AC power cord at the back of the unit and connect it to a power outlet.
TURNTABLE OPERATION
Turn the unit on by switching the VOLUME ON/OFF SWITCH (3) to the ON position.
1. Select the function switch to the PHONO position
2. Set the speed control switch to desire speed (331/3 or 45 , 78rpm).Place the record
on the turntable.
3. Adjust the Volume switch (3) set to the mid range.
4. Pull the TONE ARM (14) slightly to the right side until hear the “click” sound to activate
the turntable.
5. Manually move the tone arm over the record and gently place at the beginning of
the desired track. Readjust the VOLUME control
6. At the end of the record, the tone arm will automatically return to its arm rest. The
red power light will remain on until the unit is turned off.
.
Accessory: ADAPTER FOR 45RPM
TO PLAY THE 45RPM RECORD, PLACE THE ADAPTER (10) ON THE SPINDLE(19).
UNPACKING THE TURNTABLE
1. Carefully remove unit from it's styro-foam and take it out of the plastic bag.
2. Open lid and remove black tie-wrap by untwisting and gently sliding out from under
tone arm.
3. Remove cardboard shipper.
4. Remove white protective needle cover by gently pulling towards
front of unit.
5. Using your fingers, turn large chrome screw clockwise until it is all the way down. Do
not force it. This allows turntable to float on its shock absorbers.
6. Release tone arm hold down clip by gently pushing to the right.
This will unlock tone arm from its arm rest. Re-lock the hold
down clip when moving the unit to another location.
POLARIZED ELECTRICAL PLUG INSTRUCTIONS
This product is equipped with a polarized alternating current line plug (a plug having
one blade wider than the other). This plug will fit into the power outlet only one way.
This is a safety feature, If you are unable to insert the plug fully into the outlet, try
reversing the plug. If the plug should still fail to fit, contact you electrician to replace
your obsolete outlet. Do not defeat the purpose of the polarized plug.
RADIO OPERATION
1. Switch the unit ON by turning the POWER switch (3) to the ON position.
2. Place the VOLUME controls (3) in mid-range position.
3. Select the desired wave band by placing the BAND selector (5) in either the FM or
AM position.
4. Readjust the VOLUME controls (3) to suit your personal preference.
5. Switch the unit OFF by turning the POWER switch (3) to the OFF position.
6. For FM operation, the unit is provided with a wire antenna. Move the wire until the
reception is clear and with no interference. Do not connect external FM antenna to
an outside antenna. The AM reception may be improved by relocating the entire
radio or turning it side to side.
ANTENNA
For FM reception, a wire is provided. Move the wire until the reception is clear.
Do not connect the external FM antenna to any other antenna.
CASSETTE OPERATION
1. Turn the POWER switch (3) to the ON position.
2. Insert a pre-recorded cassette tape into the tape slot, with the exposed piece of tape
facing to the bottom, by pushing the cassette against the CASSETTE DOOR (8). The
cassette will slide into the tape mechanism and the radio which will be automatically
cut-off, once this occurs.
Note: One end of the cassette tape will remain visible.
3. Readjust the VOLUME controls (3) to suit your personal preference.
4. The cassette can be advanced in the fast forward mode, by depressing the EJECT/F.F.
button (9) half-way in. Pushing the EJECT/F.F. Button (9) again will stop the fast forward
mode and return the tape mechanism to the play mode.
5. Depressing the EJECT/F.F. Button (9) completely in, will eject the cassette from the
unit. At this time, radio operation will resume.
6. When the tape reaches its end in the play mode, the cassette will automatically stop
and radio operation will resume.
TROUBLE SHOOTING GUIDE
TURNTABLE
The unit does not operate.
The AC power cord is not connected to a power outlet.
The unit is not turned on : rotate the VOLUME knob from the OFF position
No sound is coming from unit.
The white protective needle cover was not removed.
The volume is not turned up.
Tone arm will not move.
Black tie-wrap was not removed from underneath tone arm
Tone arm hold down clip was not released.
RADIO
No radio
The function switch is not in the correct position. Turn function switch insert to
RADIO.
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio station.
CASSETTE TAPE
Cassette tape cannot be inserted
The cassette tape is inserted in the wrong position.
No cassette playback
The cassette tape is not pushed all the way in.
Adjust the volume knob.
The cassette has reached the end of the side being played. Open cassette tape
door, take out tape, flip over the cassette and reinsert.
Needles are available for additional charges,
please call us at 1-800-926-7801 for assistance
www.crosleyradio.com
LOCATION OF PARTS
1. SPEAKER
2. DIAL DISPLAY
3. ON-OFF SWITCH / VOLUME CONTROL
4. TUNING KNOB
5. AM/FM/PHONO BAND SWITCH
6. POWER PLUG
7. FM ANTENNA
8. CASSETTE DOOR
9. EJECT/F.F BUTTON
10. ADAPTER FOR 45 RPM RECORDS
11. SPEED CONTROL SWITCH
12. CUE LEVER
13. TURNTABLE
14. TONE ARM
15. ARM REST
16. HOLD DOWN CLIP
17. RED POWER LIGHT
18. LARGE CHROME SCREW
19.SPINDLE
6 3 4 5 2
9
8 7
1
15
19
10 18 12
11
14
17 13
16