Kenmore ELITE 3233 - Manual (Page 11)

Setting Surface Burner Controls
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of flame that you can control for two different heat
levels, one for small and one for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking utensil centered over the dual surface Burner Grate.
2. Push the surface control knob down and turn counterclockwise out of the OFF
position.
3. Release the knob and rotate to the LITE position (Figures 2 & 3). Note: All electronic
surface ignitors will spark at the same time. However, only the selected surface
Burner will lite.
4. Visually check that the burner has lit.
5. When the burner is lit, continue to turn the control knob counterclockwise between
the HI position and the MED position to adjust to the desired flame size for both
burners together (figure 1). DO NOT cook with any of the surface control knobs in
the LITE position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual surface Burner Grate.
2. Push the surface control knob in and turn counterclockwise out of the OFF position
(See Figures 2 & 3).
3. Release the knob and rotate to the LITE position. Note: All electronic surface
ignitors will spark at the same time. However, only the Dual Burner will ignite.
4. Visually check that zone A & B of dual burner has lit.
5. Continue to turn the gas control knob counterclockwise past the MED position; zone
B will turn off. Adjust the simmer flame size by turning the control knob between the
MED position to the LO position. DO NOT cook with the surface control knob in the
LITE position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
Figure 1
Figure 2