Operating the dishwasher, A warning, Loading the dishwasher – Kenmore 630.1395 User Manual
Page 15: Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING THE DISHWASHER
Canceling a cycle
•
Open the door slightly to stop the cycle.
•
Wait for a few seconds before opening the door all the
way.
•
Hold down the “POTS & PANS” and “CHINA GENTLE”
button until the display shows “0”.
•
Close the door. The dishwasher will drain any remaining
water.
ADDITIONAL FEATURES
Countdown Display
The countdown display indicates the time remaining for a
cycle to complete. The time will change based on water
temperatures and control settings.
Cycle Completion Signal
The cycle completion signal alerts you when a cycle
completes and the dishwasher has washed and dried the
dishes. You can choose to disable the tone or adjust the
volume.
NOTE: The unit must be powered OFF before activating/
deactivating.
To activate or deactivate:
•
Press and hold the “CHINA GENTLE” button and the
“POWER” button simultaneously.
•
When the light on the “CHINA GENTLE” button you are
pressing illuminates and a tone is heard, release both
buttons.
•
Press the “CHINA GENTLE” button until you achieve the
desired volume or until there is no tone (to turn off).
•
Press the “POWER” button to save the setting.
Dry Assist
With th is option you can raise the temperature of the
rinse water and increase the drying time for improved
drying.
To use this feature:
•
Select the desired cycle first.
•
Then press the “DRY ASSIST” button.
•
Close the door to begin the cycle.
Time Assist
Reduces the amount of time it takes to complete a cycle
while maintaining a high performance level.
To use this feature:
•
Select the desired cycle first.
•
Then press the “TIME ASSIST” button.
•
Close the door to begin the cycle.
Changing
a
cycle
If you need to change the running cycle to a new cycle,
follow the instructions below:
Open the door slightly to stop the cycle.
•
Before opening door all the way, wait a few seconds
for water to drain to the base of dishwasher tub.
•
Press both the “POTS & PANS” and “CHINA GENTLE”
buttons to reset. The display shows “0”
•
Press the POWER button to turn the unit off. Now turn
unit on again.
•
Select new cycles and options.
•
Close the door to begin cycle.
INDICATOR LIGHTS
Sanitized Indicator
When the “Sanitized” symbol illuminates on the control
panel , it means that the items that were just washed
have been sanitized according to the requirements of the
National Sanitation Foundation (NSF). For more information
on NSF certification, refer to the Dishwasher Cycles and
Options section of this manual. (The indicator light will come
on for the cycles marked with an asterisk in the cycles and
options table)
.
.
Refill Rinse Agent Indicator
The symbol shown above will illuminate to alert you when
more rinse agent is required.
Indicator
If this symbol illuminates it usually means that unit is not
getting water. Please check your water supply valve
located behind the dishwasher.
SmartLight
Blue LED illuminates the floor to indicate that the dishwasher
IS
running.
A
WARNING
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not fully
open the door until water noises have stopped.
15