Kenmore TRIO 596.755024 - Manual (Page 23)

I Care and CIcaninj
Replacing Light Bulbs
A WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, reconnect power.
A CAUTION
To avoid personal injury or property damage,
observe the following;
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Fresh Food Section
Cstyle of light shield varies]
1. Slide clear light shield
toward back of
compartment to release
from light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater than 40
watts.
4. Replace light bulb cover by inserting tabs on light
shield into liner holes on each side of light
assembly. Slide shield toward front of refrigerator
until it locks into place. Do not force shield beyond
locking point. Doing so may damage light shield.
Freezer Cstyle of light shield varies)
1. Reach behind the light
cover,
2. With firm pressure, press
forward on the notches at
the back of the cover and
pull down. The cover will
open from the back.
3. Remove the cover.
4. Remove light bulb.
5. Replace bulb with
appliance bulb no
greater than 40 watts.
6. Insert front tabs of light
cover into slots in freezer
liner and snap rear
portion over light
assembly until rear tab
engages.
'.tr:;
■