CDA EVPK9 - Manual (Page 12)

11
Installation
11. Mount the upper chimney section onto the frame
section and secure in position using the 2 screws (A) as in
Fig 13.
12. Carefully slide the lower section over the upper section
and tape it in position (L) near the shortest position.
13. Fit 2 screws into the holes on the body of the hood (O),
leaving approximately 3mm protruding.
14. Mount the main motor body to the screws (O) through
the keyed slots, as shown in Fig 14 and secure the
body in position using 4 additional screws (N) and by
tightening screws (O) firmly.
15. Connect the ducting pipe to the motor as shown in
Fig 15.
16. Lower the lower chimney section into position by
removing the tape. Take care not to let the chimney
section drop onto the motor body.
Fig. 13
Fig. 14
Fig. 15