The dispenser light, Light, The dispenser lock (on some modeis) – Kenmore 10657034601 User Manual
Page 12: Dispenser, Changing the water filter, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IMPORTANT:
You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
4.
Remove the glass to stop dispensing.
NOTE:
The first few batches of ice may have an off-fiavor
from new plumbing and parts. Throw the ice away. Also, take
large amounts of ice from the ice bln, not through the
dispenser
The Dispenser Light
The dispenser area has a light. It can be turned on manually by
pressing the ON button (touchpad or rocker switch).
On some models: Whenever you use the dispenser, the lever will
automatically turn the light on.
LiGHT
OFF ON
NOTE:
See “Changing the Light Bulbs” for information on
ohanging the dispenser light bulb.
The Dispenser Lock (on some modeis)
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE:
The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the dispenser levers.
To turn off the dispenser, press the LOCK button. The indicator
will appear above the LOCK button and the ice and water
dispensers will not work. To unlock the dispenser, press the
UNLOCK button until the indicator appears. Then continue to
dispense ice or water as usual.
DISPENSER
LOCK.. UNLOCK
The water filter status light will help you know when to change
your water filter. When the status light changes from green to
yellow, this tells you that it is almost time to change the water
filter. It is recommended that you replace the filter when the
status light changes to red OR when water flow to your water
dispenser or ice maker decreases noticeably. The filter should be
replaced at least every 6 months depending on your water quality
and usage. To change the filter, see “Changing the Water Filter”
later in this section.
INDICATOR:
STATUS:
GOOD (green)
New filter installed
ORDER (yellow)
Order filter
REPLACE (red) OR
when water flow decreases
Replace water filter
After changing the water filter, reset the status light by pressing
and holding the RESET button for 2 seconds. The status light will
change from Replace (red) to Good (green) when the system is
reset.
W
ater
F
ilter
(500D •
ORDER • RESET •
REPiAd#
Do not use with wafer that is microbiologically unsafe or
of unknown quality
without
adequate
disinfection
before
or after the
system. Systems certified
for cyst reduction
may be used on
disinfected waters
that may contain
filterable cysts.
Changing the Water Filter
The water filter is located in the base grille below the freezer
compartment door. It is not necessary to remove the base grille
to remove the filter.
1
.
Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
NOTES:
■
Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
replace the cap and pull the filter straight out.
■
There will be water in the filter. Some spilling may occur.
2
.
3.
Remove the cap by turning it counterclockwise until it stops.
IMPORTANT:
Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
Take the new cartridge out of its packaging and remove the
protective cover from O-rings.
A
B
A. Protective cover
B. O-rings
12