Kenmore 790.9081 - Manual (Page 13)

General Care & Cleaning
Cere and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the Cleaning Table provided at the beginning of the General Care &
Cleaning section in this Use & Care Guide.
Oven
Light
Changing the Oven Light (some models)
On some models, the oven light automatically turns on when the door is
opened. Some models have a switch located on the control panel to turn on the
light. The oven light bulb is located at the rear of the oven.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug the range back in).
4. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
^CAUTION Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
Removing and Replacing the Oven Door
4Û^CAUTI0N I The door is heavy. For safe, temporary storage, lay the door flat
with the inside of the door facing down.
To Remove Oven Door;
1.
2
.
3.
4.
5.
6
.
Open oven door completely (horizontal with floor - See Fig. 1).
Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
Insert the 2 screws into the door hinge holes located on the side of the hinge
arm, one into each hinge (See B Fig. 2).
Close oven door until the door stops (Do not force the door to close any further).
The placement of these screws should keep door open in about a 45 degree
position.
Grasp oven door firmly on both sides and slide door up and off hinges at the
same angle. (See Fig. 3)
To clean oven door, follow the instructions in the General Care & Cleaning
Table.
To Replace Oven Door:
1. Be sure the hinge arms remain at the 45 degree angle position. Be sure the
screws are still locking the hinge arms from moving. If the screws fall out of the
hinge holes, the hinge(s) may snap back against the oven frame and could
pinch fingers or chip the porcelain finish on the oven front frame.
2. Hold door at the sides near the top while resting the lower front of door on your
knee. Insert the door channels at the bottom of door over the door hinges, (See
Fig. 3).
3. Allow the door to slide down into the door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted into the bottom corners as far as
they can go.
4. Open door completely (horizontal with floor) and remove both screws from
holes in door hinges.
5. Reinstall the 2 screws into the door liner (See C Fig. 2).
6. If the door is not in alignment with the oven frame, remove door and repeat the
above steps.
n
»
:c
13