Kenmore 465.1333 - Manual (Page 18)

13
C
are and
C
leaning
Coarse Filter Cap
The coarse filter cup is
located on the floor of the
dishwasher drawer. It is
designed to collect large
food and non-food
items that cannot be
processed through the
dishwasher disposal
system, i.e. bone,
broken glass, etc.
Check and empty the
coarse filter cup if food
soil remains on the
coarse filter plate. This
ensures foreign objects
are not recirculated through a cycle, causing possible
damage to dish load.
Important Do not start the dishwasher until the
coarse filter cup is securely in place and flush with the
coarse filter plate. Doing so may damage the
dishwasher motor and/or spray arm.
Cleaning the coarse filter plate and coarse filter cup:
If coarse filter plate accumulates food soil, cleaning of
the coarse filter cup is needed.
Three-piece rack (select models)
1. Make sure that the dishwasher drawer is cool before
you clean the coarse filter plate and coarse filter cup.
Pull drawer out to
its full extension.
Make sure the rack
is empty. Fold the
variable tines along
the back flat on
the rack. Grasp
the front center of
the rack and pivot
upward to access
the coarse filter cup.
3. Wipe the coarse filter plate with a damp cloth in a
clockwise motion.
4. To remove the coarse filter cup, unscrew the small
cap turning in a counterclockwise motion. Lift and
remove the coarse filter cup out of the drawer.
5. Empty the cup of hard objects and food soil. Rinse
cup under hot water.
6. Place the coarse filter cup back into the coarse filter
plate and tighten the cap, turning in a clockwise
motion. Make sure the coarse filter cup is flush
with the coarse filter plate.
7. Pivot the center rack downward to its original
position.
. _ ^ 1 , r
n- ;
,TS V'-v'
,'/p \ ■
Notes: Removal of the center rack is not
recommended, however if it is needed;
• Pull drawer out to its full extension. Make sure
the rack is empty. Fold the variable tines along
the back flat on the rack. Grasp the front center
of the rack and pivot upward.
• Pivot the rack
toward the left.
• Pull the rack
toward the front of
the drawer and lift
up to remove.
To reinstall the j
rack:
Place the hook in the loop on the back left corner
of the rack.
Pivot the rack to the right, then pivot downward
to its original position.
17