Connect mmt, Remove the door, Reverse the hinge and hinge cover – Kenmore ELITE HE4 110.9586 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connect Mmt
1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
You can change your door swing from a right-side opening to a
left-side opening, if desired.
Remove the door
1. Place a towel or soft cloth on top of the dryer or work space
to protect the surface.
2. Open the dryer door. Remove the 4 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening last (
2
nd
from the top).
A. Dryer
B. Do not remove
C. Dryer door
3. Lift and pull forward on the door so that the keyhole clears
the screwhead. Remove the door.
4. Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the last screw from Step 1.
Remove the
6
screws to release the outer door assembly
from the inner door assembly, as indicated below. See
illustration. It Is important that you remove only the
6
indicated screws.
5. Lift the inner door assembly off of the outer door assembly.
Set the outer door assembly aside.
Reverse the hinge and hinge cover
1. Place the inner door, screwhead side up, on the work space.
2. Gently pull the plastic cover out and down. This unsnaps the
plastic hinge cover from the inside door assembly.
3. Remove the 4 screws that hold the hinge to the door.
4. Move the 2 large hole screw plugs to the opposite side and
insert in the original screw holes.
B
A. Hinge sorews
B. Hole screw plugs
5.
6.
Move hinge to the other side and reattach with the 4 screws
removed In Step 3.
Reverse the plastic cover. Slide it up over the inner door
assembly edge and gently snap into place.
7. Set the inner door assembly aside.
13