Cobra Electronics CP-705 - Manual (Page 3)

The following features offer state-of-the-art performance and the ultimate in
user-friendly convenience with your new Cobra INTENNA cordless telephone.
AUDIO PERFORMANCE
Your Cobraphone has Clear Call® PLUS
Circuitry with compander noise-reduction
system for optimum audio performance
without background noise.
AUTO STANDBY
This feature enables answering and plac-
ing calls just like a corded phone. (See
page 4 for instructions on activating this
feature.)
BATTERY SAVER CIRCUITRY
The handset of this phone may be kept on
standby mode (TALK light OFF) for a few
days at a time in a convenient location
away from the recharging base. In this
condition, it is ready to answer or place
calls by pressing and releasing the TALK
button. The duration of the battery saver
feature will depend on your actual use of
the phone in its remote location.
Note: A warning beep tone will sound
(and the BAT indicator will flash) when the handset batteries need overnight
recharging.
Operational Features
(5)
DIGITAL CODING
TALK
TALK
BAT LOW
1 2 3
4 5 6
7 8 9
✱ 0 #
REDIAL FLASH CHAN
Cobra ®
INTENNA
1 0 C H A N
N E L
CHANNEL SELECTION
Ten selectable transmitting/receiving channels (the maximum available) are built
into your Cobra INTENNA for optimum interference-free use.
You may need to change channels if you experience interference (noise, static,
or poor audio):
• With TALK light on, press and release the CHAN button on the handset
to advance to a new channel. A series of beep tones (2 groups of 2
beeps) will sound to indicate successful channel change.
• An alert tone (three beeps) will sound if a new channel is unavailable
due to interference. In that case, move closer to your cordless base and
try to change channels again.
PHONE
NUMBER
DISPLAY
WINDOW
REDIAL
BUTTON
TALK BUT-
TON
TALK & BAT-
TERY LOW
INDICATOR
FLASH
BUTTON
CHANNEL
BUTTON
(4)
Using Your Phone
After charging the handset batteries overnight (at least 12 hours), use your
Cobra INTENNA cordless phone like any corded phone. With Cobra’s AUTO
STANDBY feature, just pick the handset up to answer or place a call.
ANSWERING/PLACING CALLS AT THE BASE WITH “AUTO STANDBY” and
"AUTO ANSWER"
• Activate AUTO STANDBY by pressing and releasing the TALK button on
the handset. The TALK light will illuminate.
• Return handset to base without pressing the TALK button. Now there
will be no need to use the TALK button to answer a call unless you keep
the handset away from the base for extended periods (see below). When
the phone rings, just pick up and talk.
• After placing or answering a call, return the handset to the base without
pressing the TALK button; your phone automatically disconnects the
call and resets the AUTO STANDBY feature.
• To place a call, lift the handset and press the TALK button. Listen for dial
tone and dial the number.
REMOTE ANSWERING/PLACING CALLS (AWAY FROM THE BASE)
• The TALK indicator (the lighted TALK button) must be OFF when the
handset is away from the base. The phone is now in STANDBY mode,
ready to ring if a call is received.
• Press and release the TALK button (the indicator will light) to answer or
place a call.
• Press and release the TALK button when finished with a call in order to
“hang up” the phone.