Kenmore ULTRASOFT 400 625.3884 - Manual (Page 20)

JJJJJJJJJJJJJJJ
JJJJJJJJJJJJJJJ
JJJJJJJJJJJJJJJ SECTION 4 JJJJJJJJJJJJJJJ.
JJJJJJJJJJJJJJJ
JJJJJJJJJJJJJJJ.
KNOW ABOUT YOUR WATER SOFTENER
FIG. 13
A. DIMENSIONS / SPECIFICATIONS
FIG. 14
A
i I
j [EEEEEEEEEE
m m m r ¿ 1 i m m m m m m m m m m EE f -H iPPPPPffwww
ipppppppprffl
Ë jjjjjjjjjjjjjjjjj I
JJJJJJJJJJJJJJJJJ
jjjjjjjjjjjjjjjjj I
, \ /
' V.____________^ y J '!___ r U
Inches CM
A Salt Tank Height 40-1/4 102.2
B Resin Tank Diameter
(nominal) 9 22.7
C Resin Tank Height
(nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 47-3/4 121.3
F1 Length 19-1/2 49.5
F2 Width 16-1/2 41.9
— Distance between inlet-
outlet center lines
3-7/8 9.8
BYPASS VALVES
Bypass valve(s) should always remain in soft
water service position. Position in "bypass" only
if needed for softener repairs.
SINGLE BYPASS
PULLOUT
for service
PUSH IN
for bypass
3 - VALVE BYPASS
FOR SERVICE
close bypass valve
open Inlet & outlet valves
FOR BYPASS
open bypass valve
close Inlet & outlet valves
Bypass
Valve
Inlet
Valve
MODEL NOS. 625.388400 & 625.388450 TIMER HF CODE HF32
Note: Please see the rating decal for operating capacity, salt usage and service flow rate/pressure loss
performance specifications. Performance specifications are validated by the Water Quality Association
(WQA). The rating decal is located on the rim, under the salt hole cover (see page A, inside front cover).
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm).... 3
Minimum-Max. water pressure (psi)-- 20- 125
Minimum-Max. water temperature (°F) - 40- 120
Maximum water hardness (gpg)........ 110
Maximum “clear water” Iron (ppm)---- 8
SALT FOR WATER SOFTENER
Type of salt needed............................ nugget or pellet
Alternate type of salt........................... pure, evaporated,
compacted water
softener salt
Salt storage capacity (lbs).................. 200
4
-
1