Remote control, Remote control operations, How to insert batteries into remote control – Kenmore 580. 75063 User Manual

Page 12: Operation, I> fs

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

REMOTE CONTROL

Note: The Remote Control will not operate properly if

strong light shines on the sensor window of the Air

Conditioner or if there are obstacles between the Remote
Control and the Air Conditioner,
Every time you push button, you will hear beep sound

from the Air Conditioner.

1

6

<i> fS

FIG. 15

REMOTE CONTROL OPERATIONS

1. POWER

• To turn the air conditioner ON, push this button.

To turn the air conditioner OFF, push the button

again.

• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High

fan speed. Temperature setting at 72°F.

2. TEMPERATURE SETTING

• Use this button to automatically control the

temperature of the room.
The temperature can be set within a range of 60°F to
86 ’F by increments of 1°F.

3. MODE

- Every time you push this button, it wtl! shift among

COOL. ENERGY SAVER and FAN.

-ENERGY SAVER
• The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on and
the unit will check the room air to determine if cooling

is needed.

4. FAN SPEED

■ Every time you push this button, it advances the setting

as follows: {High(F3) ^ Low(F1 ) Med(F2) High(F3)}

5. TIMER

- SHUT-OFF TIME
• You will usually use shut-off time while you sieep.
• With unit running, use Timer to set number of hours

until shut-off,

• For your sleeping comfort, once Time is set, the

Temperature setting will raise 2’F after 30 min. and
2°F after another 30 min.

• Every time you push Timer button, it advances the

Timer setting as follows: 1 Hour — 2 Hours — etc. -*

12 Hours maximum.

- START TIME
• With unit not running, use timer to set number of

hours before unit starts.

• Every time you push Timer button, it advances the

Timer setting as follows: 1 Hour 2 Hours -• etc.

12 Hours maximum.

HOW TO INSERT BATTERIES

INTO REMOTE CONTROL

1. Remove the cover from the back of the remote controller.

2. insert two batteries.

• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.

3. Re-attach the cover.

IG. 16

Do not use rechargeable batteries. Such batteries

differ from standard dry ceils in shape, dimensions, and
performance.

Remove the batteries from the remote controller if the air

conditioner is not going to be used for an extended
length of time.

In order to prevent discharge, remove the batteries from

the remote control if the air conditioner is not going to be
used for an extended period of time. Keep the remote
control away from extremely hot or humid places. To
maintain optima! operation of the remote control, the
remote sensor should not be exposed to direct suniight.

The remote control can be mounted on a wall using the

mountable holder.

FIG. 17

12-

Advertising
This manual is related to the following products: