Chauvet 700 - Manual (Page 6)

Page 6 of 12 Hurricane™ 700 User Manual (Rev. 08)
3. S
ETUP
AC Power
This product is not switching. It is model-specific. It may run on either 120V, 60 Hz or
230 V, 50 Hz.
To determine the power requirements for a particular product, see the label affixed to
the back plate of the product or refer to the product’s specifications chart. A product’s
listed current rating indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Replacing the Fuse
Unplug the IEC power cable before replacing the fuse!
This product has a replaceable fuse. In the event that the fuse needs to be replaced,
follow the instructions provided below.
1. Using a flat head screwdriver, remove the fuseholder from the IEC housing.
2. Remove the bad fuse from the fuseholder.
3. Insert the new fuse into the fuseholder.
4. Install the fuseholder in the IEC housing.