Pioneer AVX-7000 - Manual (Page 12)

Connecting the Units
Note:
This product is for vehicles with a 12-volt battery
and negative grounding. Before installing it in a
recreational vehicle, truck, or bus, check the bat­
tery voltage.
To avoid shorts in the electrical system, be sure
to disconnect the © battery cable before begin­
ning installation.
Refer to the owner’s manual for details on con­
necting the power amp and other products, then
make connections correctly.
Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
Route and secure all wiring so it cannot touch
any moving parts, such as the gear shift, hand­
brake and seat rails. Do not route wiring in
places that get hot, such as near the heater outlet.
If the insulation of the wiring melts or gets torn,
there is a danger of the wiring short-circuiting to
the vehicle body.
Don’t pass the yellow lead through a hole into
the engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
Do not shorten any leads. If you do, the protec­
tion circuit may fail to work when it should.
Never feed power to other equipment by cutting
the insulation of the power supply lead of this
product and tapping into the lead. The current
capacity of the lead will be exceeded, causing
overheating.
When replacing fuse, be sure to use only fuse of
the rating prescribed on the fuse holder.
If this product is installed in a vehicle that does
not have an ACC (accessory) position on the
ignition switch, the red lead of this product
should be connected to a terminal coupled with
ignition switch ON/OFF operations. If this is not
done, the vehicle battery may be drained when
you are away from the vehicle for several hours.
No ACC position
A CAUTION
• Cords for this product and those for
other products may be different colors
even if they have the same function.
When connecting this product to another
product, refer to the supplied Installation
manuals of both products and connect
cords that have the same function.
About the V.SEL cable
Use to connect to an Audio Visual Master Unit,
TV tuner or other component featuring a V.SEL
cable connection jack. If you have an Audio
Visual Master Unit and a TV tuner, give priority
to connection of the Audio Visual Master Unit.
Note:
When connecting the TV tuner refer to the TV
tuner Installation Manual.