Pioneer CD-ROM Drive DR-UO6S - Manual (Page 8)

SPECtFICATIONS
TROUBLESHOOTING
12 cm { 4.72 in ), 8 cm (3.15 in
[General functions]
Disc diameter
Transfer rate
Sustained 2,100 - 4,950 kBytes/sec*
* The data transfer rats may not be output for some disc conditions {scratches, etc.i.
Seek time
Random (average)
Access time
Random (average)
Data buffer capacity
[Audio output part]
Line
[Others]
Power supply
(With the built-in terminator)
Externa! dimensions
Weight
Operation temperature
Operation humidity
Storage temperature
Storage humidity 5% to 90% (no condensation)
[Accessories]
• Software device drive disk x 1
• Short-circuit socket x 4
• Audio cable x 1
• Mounting screw x 4
• Pin for emergency ejection x 1
• Operating instructions x 1
• Installation instructions x 1
NOTE:
Specifications and design subject to possible modifications without notice, due to improvements.
60 ms
70 ms
128 kBytes
0.7 Vrms ± 0.1 Vrms (at 10 kii load)
DC +12 V, 0,9 A (peak), 0.55 A (normal)
DC +5 V, 1.8 A (peak), 0.75 A (normal)
148 (W) x42.3 (H) X 207.5 (D) mm
5-27/32 (W) X 1-11/16 (H) X 8-6/32 (D) in
0.99 kg ( 2.2 lb )
+ b"Cto +45'C(41T to 113T)
5% to 85% (no condensation)
- 40’C to +60'C ( -40"F to 140T }
Published by Pioneer tlectronic Corporalion,
Copyright 'C 1997 Pioneer Eloetronie Corporation.
All rigtils reserved.
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something
wrong with this unit, check the points below according to the symptom.
If your computer did not start up correctly because the initial diagnostics did not recognize a SCSI
device, check these items:
• Were all of your SCSI devices plugged in and turned on before you started your computer ?
The Drive and all of the SCSI devices in the daisy chain must be turned on before you start your
computer.
• Are your cables connected properly ?
All cables must be attached to the correct ports.
• Are your SCSI IDs set properly ?
Each device on a SCSI chain must have a unique SCSI ID.
• Have you set termination properly ?
If the Drive is the on/y SCSI device, it must be terminated.
• Have you installed the software driver properly that came with your Drive ?
If you have not installed the software device drivers yet, refer to the Installation instructions.
if data cannot be read from the CD-ROM disc:
• Is this disc properly inserted in the slot with the label side facing t UP ?
• Is the BUSY indicator light on ?
• Is the disc in proper operating condition ?
• Is the SCSI cable connected correctly to the interface card and/or other SCSI devices ?
• Are you sure there is a disc in the slot (drive) you are trying to access ?
if music cannot be piayed back;
• Are you sure an audio CD is being used ?
• Is the audio amplifier, powered speakers, or headphone set connected ?
• Are you using CD-DA Audio ?
Some audio formats require an audio sound card in the computer to decode digital Audio CD-DA.
• Are you operating the Drive that is not connected to a SCSI 2 interface card ? Bringing digital audio
from the CD-ROM disc into the computer requires a SCSI 2 interface card.
• Is the volume turned high enough ?
24
<DRCl07b>
En
22
<DRC1076>
En