Pioneer GEX-P7000TVP - Manual (Page 4)

Installation <ENGLISH>
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connected
up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica­
tions of the vehicle.
• Install the unit where it does not get in the dri­
ver’s way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• When mounting this unit, make sure none of the
leads are trapped between this unit and the sur­
rounding metalwork or fittings.
• Do not mount this unit near the heater outlet,
where it would be affected by heat, or near the
doors, where rainwater might splash onto it.
• Before drilling any mounting holes always check
behind where you want to drill the holes. Do not
drill into the gas line, brake line, electrical wiring
or other important parts.
• If this unit is installed in the passenger compart­
ment, anchor it securely so it does not break free
while the car is moving, and cause injury or an
accident.
• If this unit is installed under a front seat, make
sure it does not obstruct seat movement. Route all
leads and cords carefully around the sliding mech­
anism so they do not get caught or pinched in the
mechanism and cause a short circuit.
MODE Switch Setting
Before installing, use a pen tip or other
thin, pointed instrument to set the
MODE Switch on the bottom of this
product to the appropriate position for
the component you are using it with.
FM MODULATOR
IP-BUS MAIN UNIT
IP-BUS AV MASTER
Installing the Unit
I Mounting with Brackets (Fig. 1)
1. Tapping screw (4 x 12 mm)
2. Screw ( 4 x 8 mm)
3. Bracket
4. Drill 2 to 2.5 mm diameter holes.
5. Car mat or chassis
I Mounting with Velcro Tape (Fig. 2)
Thoroughly wipe off the surface before affixing
the velcro tape.
1. Velcro tape
2. Car mat or chassis