Pioneer AVX-P7000CD - Manual (Page 4)

Installation <ENGLISH>
Note:
• Before finally installing this product, connect the
wiring temporarily, making sure it is all connected
up properly, and this product and the system work
properly.
• Use only the parts included with this product to
ensure proper installation. The use of unauthorized
parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other
modifications of the vehicle.
• Install this product where it does not get in the
driver’s way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
• If installation angle exceeds 30° from horizontal,
this product might not give its optimum
performance. (Fig. 1)
DIN Front/Rear-mount______________
This product can be properly installed either
from “Front” (conventional DIN Front-mount) or
“Rear” (DIN Rear-mount installation, utilizing
threaded screw holes at the sides of product chas­
sis). For details, refer to the following illustrated
installation methods.
DIN Front-mount
■ Installation with the rubber bush (Fig. 2)
1. Dashboard
2. Holder
After inserting the holder into the dashboard,
then select the appropriate tabs according to the
thickness of the dashboard material and bend
them.
(Install as firmly as possible using the top and
bottom tabs. To secure, bend the tabs 90
degrees.)
3. Rubber bush
4. Screw
Removing this product (Fig. 3) (Fig. 4)
Frame
Pull out to remove the frame.
(When reattaching the frame, point the side with
a groove downwards and attach it.)
Insert the supplied extraction keys into this
product, as shown in the figure, until they click
into place. Keeping the keys pressed against the
sides of this product, pull this product out.
DIN Rear-mount_________
■ Installation using tbe screw boles on
tbe side of this product (Fig. 3) (Fig. 5)
(Fig. 6)
1. Remove the frame.
5. Frame
Pull out to remove the frame.
(When reattaching the frame, point the side with
a groove downwards and attach it.)
2. Fastening this product to the factory radio
mounting bracket.
7. Select a position where the screw holes of the
bracket and the screw holes of this product
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use any of truss
screws ( 4 x 3 mm), truss screws ( 5 x 6 mm) or
flush surface screws ( 5 x 6 mm), depending on
the shape of the screw holes in the bracket.
*1 Use truss screws ( 4 x 3 mm) only.
8. Screw
9. Factory radio mounting bracket
10. Dashboard or Console