Cycle status indicators, Sensing, Heating – Kenmore ULTRA WASH 665.16837 User Manual

Page 16: Sanitized, Clean, Active vent, Drying system, Overfill protection float, Washing special items

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

To delay the start

1. Close the door,

2. Select a wash cycle and options.

3. Repeatedly press

( D

elay

)

\HOURW

until you see the desired hours of deiay in the display.

When the delay reaches 12 hours, the delay turns off. Press

DELAY HOURS again to select a new number of delay hours,

4. Press START.

NOTE:

To cancel the delay, press CANCEL/DRAIN until all Delay

Hours lights are off.

IMPORTANT:

Operate your dishwasher only when you are at home.

If your home is equipped with a water softener, do not start
the dishwasher during the regeneration of the softener.

Cycle Status Indicators

Follow the progress of your dishwasher with the Cycle Status

indicators.

S

ensing

H

eating

S

anitized

C

lean

Sensing

Your dishwasher senses the soil level on the dishes. Soil level

determines the length of some cycles, the amount of heat added

to the wash or rinse, and the cycle needed for the load. SENSING

glows during the soil sensing parts of the cycle. Wash action
continues while sensing occurs.

Heating

HEATING glows, and the cycle progression pauses, whenever
water is heated during a cycle. Wash or rinse action continues as
the water heats.

Sanitized

If you select the Sani Rinse option, SANITIZED glows when the
Sani Rinse cycle is finished, if your dishwasher did not property
sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle Is interrupted. The light goes off when
you open the door.

Clean

CLEAN glows when a cycle is finished. The light turns off when

you open the door or press Cancel/Drain.

Active Vent

The Active Vent reduces the sounds from your dishwasher. The

cover closes after the cycle starts. Filling and washing sounds are
reduced. The Active Vent opens when wash action ends and
vapor is vented into room.

NOTE:

There is a slight noise when the cover closes or opens.

This is normal.

Drying System

During drying, you can see steam escaping through the vent at

the upper left corner of the door. This is normal as the heat dries

your dishes.

IMPORTANT:

The vapor is hot. Do not touch the vent

during drying.

Overfill Protection Float

The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be

in place for the dishwasher to operate.

Check under the float for objects that may keep the protector
from moving up or down.

WASHING SPECIAL

ITEMS

If you have doubts about washing a particular item, check with

the manufacturer to see if it is dishwasher safe.

Material

Dishwasher Safe?/Comments

Aluminum

Yes

High water temperature and detergents
can affect finish of anodized aluminum.

Disposable

No

Aluminum

Do not wash throwaway aluminum pans
in the dishwasher. These might shift

during washing and transfer black marks
to dishes and other items.

Bottles and Cans

No

Wash bottles and cans by hand. Labels
attached with glue can loosen and clog
the spray arms or pump and reduce
washing performance.

Cast Iron

No

Seasoning will be removed and iron will

rust.

China/

Yes

Stoneware

Always check manufacturer’s

recommendations before washing.
Antique, hand-painted, or over-the-glaze
patterns may fade. Gold leaf can discolor
or fade.

16

Advertising