Honeywell T6051 User Manual
Mounting, Location
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
H O N E Y W E L L I
T R A D E L I N E
I C O N T R O L S
T6051 A; T6052A.B
HEAVY DUTY THERMOSTATS
The T6051 Heavy Duty Thermostat may be used in
heating only systems, cooling only systems, combination
heat-cool systems (system changeover means must be
provided), or as a series 60 controller for valves or motors.
The T6052A is for two stage heating or two stage
cooling systems. The T6052B is for one stage heating-
cooling systems with automatic changeover.
The Q651 Subbase may be used with the T6051 and
T6052B thermostats to provide system witching at the
thermostat location. Refer to applicable specification
sheet for additional information.
MOUNTING
1.
If mounting horizontally, coverplate must be
changed. To remove vertical coverplate, bend four
corner tabs to outside and oush out on cover. Place
horizontal coverplate on cover frame and bend four
corner tabs to inside. (See Fig. 1).
INSTALLATION --- --------------------------------------—
LOCATION
Locate the thermostat about five feet above the floor
on an inside wall where it will be affected only by the
average temperature of the room. The T6051A may be
mounted either vertically or horizontally.
If using a 0651 Subbase, refer to the instructions
packed with the subbase.
Fig. 1—Changing coverplate for horizontal mounting.
THERMOSTAT
Fig. 2—Mounting Thermostat on Outlet Box.
2-72
E.S.
Form Number
95-6980-1
Residential Div.