Kenmore 116.32734 - Manual (Page 9)

ATTACHMENTS
G0ITÌlÒffìstio Ft
Brush
BxtsFisíuft
Hose
Tefesoopfc
py^Ftd
Crevice
Toot
Identily each of the attachments shown above.
Remove the upper end of the hose that is
attached to the telescopio wand by grasping
the hose collar, twisting and pulling straight
out. The attachments can now be added to
the hose.
Note: The motor protector may open
when using attachments or when cleaning
new carpet, due to reduced airflow by the
attachments themselves or by new carpet
fuzz filling the dust bin quickly. See the
TROUBLESHOOTING section.
Note: When using attachments make
sure the cleaner Is in the upright position
and the Carpet/Bare Floor setector is in
the Bare Floor position.
A
WARNING
Electrical Shock And Personal Injury
Hazard
Disconnect electrical supply before
VMa#ii infi iiic? uiiMt« i ciiiUEii:»
to do so could result in electrical
shock or personal injury from cleaner
suddenly starting.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
Telescopic Wand
Crevice Tool
Remove the
telescoping
wand from
its storage
position
by twist­
ing and
pulling
out.
On the telescopic wand turn the locking ring
clockwise to toe UNLOCK position.
Lower
Wand—--^
U ™ Suction
Cortlrol Slide
Wand
\ Locking Ring
Upper
Wand
Extend the wand to its full length. Turn the
locking ring counter-clockwise to the LOCK
position. Attach the extension wand onto the
open end of the hose.
Remove the crevice tool from its storage
position on the wand holder Attach crevice
tool to the extension wand.
A
CAUTION
IrlJSIf I jhj III i IU I ii?5 j
not to overextend the stretch hose
when reaching. Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over..